Video Instructions



Application Directions

  1. The surface should be clean and dry. Note: Wrap A Wreck Film must be applied on a dry surface but when applied it will resist moisture penetration.
     
  2. Pull a 2" - 4" starter piece from the width of the roll and apply with simple Hand pressure against surface.
     
  3. Hold the roll in both hands and begin to unwind the film over the damaged area, Overlap from the bottom to the top so that the film has a natural shingle effect.
     
  4. Apply hand pressure (where there are sharp edges or broken glass use gloves or heavy cloths) to seal adhesive.